1.Most of Ford vehicles equipped with a 31 or 33 MHz (TPMS) Tire Pressure Monitoring system,.a "Sensor Re-Learn Procedure" must be performed after tire rotations
2.Remote Control Door Lock Receiver Module replacement or Tire Pressure Sensor replacement.
3.This re-learn procedure can be performed by using EL-09 special tire pressure tool
.EL-09works on 201 Ford models too.
Step 1 - Enter leaning mode
Set the gearshift lever to "P"
Put the ignition switch to “ON”
Enter the interface of tire pressure display by DIC
DIC shows "Press Set / Ctrl to re-learn"
Press “Set / Ctrl”
The turn signal is lighted for 3 seconds and the horn beep sound twice to enter the learning mode
Step 2 - Read tire information
Start from the front-left wheel,
Make the J-6079 or Diagnostic Tool EL-09 antenna up against the valve core position & close to the rim of the tire sidewall
El-09 tire pressure tool starts by the start switch
Successful to read the tire information when the horn bleeps once
Step 3 - Same method to read other tire pressure information
Follow the instuction above to read tire pussure of the front-right, rear-right, rear-left wheels.
Turn signals is lighted for 3 seconds and the horn bleeps twice when the learning is complete.